EPOXY SLOW HARDENER 206-B WEST SYSTEM 3109100008

AED 295.00 exc. VAT

Best Use Slow Hardener for 105 Epoxy Resin
Manufacturer WEST SYSTEM
Capacity 814 ml
Manufacturer Part Number 206-B
Type Hardener
Cure Time 10 to 15 Hours (Working Time 90-110 Minutes) at 72 F

 

Description

WEST SYSTEM EPOXY SLOW HARDENER 206-B 814ML

Product Overview

206 Slow Hardener is a low-viscosity epoxy curing agent for use when extended working time or a longer cure time is needed. It also provides adequate working time at higher shop temperatures. When combined with 105 Resin in a five-part epoxy resin to one-part hardener ratio, the cured resin/206 Slow Hardener mixture yields a rigid, high-strength, moisture-resistant solid with excellent bonding and barrier coating properties. 206-B 814ml Epoxy Slow Hardener is not intended for clear coating.

Pot life at 72°F (22°C): 20 to 25 minutes
Cure to a solid state: 10 to 15 hours
Cure to maximum strength: 1 to 4 days
Minimum recommended temperature: 60°F (16°C)
Mix ratio: Resin 5:1 Hardener

No Need for Excessive Clamping Force

Unlike traditional wood glues, WEST SYSTEM 105 Resin-based epoxy mixtures including 105 Resin and 206 Slow Hardener are stronger than wood or many other substrates. Because of this, it is beneficial to have some epoxy between the objects you are gluing together. As long as the parts are held in place and epoxy is contacting the entire surface of both substrates, no clamping pressure is needed. With epoxy, the goal clamping is to simply ensure the epoxy contacts the entire surface for the duration of the cure time. Moderating clamp force is all that is required.

Pre-Warm the Resin and Hardener

Cold temperatures increase an epoxy’s viscosity, making it harder to dispense, mix and apply. Warming resin and hardener reduces their viscosity so they flow easily through their dispensing pumps. To pre-warm, place the resin and hardener containers under a warming lamp or in a warm-water bath. Pre-warmed resins and hardeners will not cling as much to your mixing equipment. They’ll also blend more easily, ensuring thorough mixing. A warmer, lower-viscosity mixture flows smoothly during application and readily penetrates porous surfaces

Dispensing and Mixing Epoxy Resin and Hardener

It is critical that you dispense epoxy resin and hardener at the correct ratio. Altering the amount of hardener does not control cure speed. Instead, it creates an epoxy mixture that can never fully cure and will have greatly reduced physical properties.

300 Mini Pumps are calibrated to deliver the proper working ratio with one full pump stroke of resin for each one full pump stroke of hardener. 105/205-206 pumps deliver approximate 0.8 fl oz of resin/hardener with one full stroke of each pump.

Preparing Surfaces

Between applying coats of epoxy, prepare the cured epoxy surfaces. When coating at cold temperatures, the slower cure can result in a waxy/greasy film on the surface of the cured epoxy, called amine blush. Remove this byproduct of the curing process before you apply the next coat of epoxy. Amine blush is easy to wash away with plain water and a 3M Scotchbrite pad. Don’t let the water evaporate. Dry the surface with plain white paper towels. Don’t use rags, because they can contaminate the surface with laundry softeners and anti-cling ingredients.

Finally, sand any remaining glossy areas with medium-grit sandpaper.